 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| UDS-10-IAP Quick Start The Unit UDS-10-IAP is a member of the Lantronix IAP (Industrial Automation Platform) family of Device Servers. IAP devices allow you to install the protocol suitable for your automation application. Follow the instructions below to connect your UDS-10-IAP and install the protocol of your choice. After you install the protocol and configure the unit, you can Ethernet-enable a serial device by connecting it to the serial port. (See the UDS-10IAP User Guide on the APS CD.) Install a Protocol The Device Server comes with the Standard Tunneling protocol installed. Follow these steps to install a different protocol such as MODBUS or DF1. Step 1: Access the Firmware 1. Insert the APS CD into your CD-ROM drive. 2. Follow the prompts in the installation wizard. The Configuration Utility Window displays. Step 2: Assign an IP Address Quick Connect Network Interface RJ45 Ethernet port (10Base-T) 1. Click the Assign IP icon. IP Address window displays. The Assign Power plug Serial Interface LEDs DB25 serial port 2. In the Enter IP Address to assign field, type the IP address of the Device Server (XXX.XXX.XXX.XXX format). 1. Connect the UDS-10-IAP to the network through the Ethernet port. (The unit must be on the same network as your computer.) 2. Connect power (9-30 VDC). 3. Verify that the green Link LED is lit. 3. In the Enter the Hardware or Ethernet Address field, type the Ethernet address (MAC address) listed on the Device Server label (on the bottom of the unit). 4. Click the Set IP Address button. The Assign IP Successful message displays. Click OK. Step 3: Ping the Device Server 1. Click the Ping icon window displays. . The Ping Device 2. Click the Ping button. The Reply received message displays in the window, indicating that the IP address has been entered successfully. Step 4: Query the Device Server 2. Click Select FW File. A list of firmware files displays. 1. Click the Device Info icon . The Query Device window displays. The IP address displays at the top. 3. Select the desired protocol and click Open. The selected file displays in the FW File field. 4. Click Download FW File. The File download successful message displays. Click OK. Note: Run another query to confirm that the protocol has been installed. Step 6: Telnet to the Device Server To view or update the Device Server configuration, open a Telnet connection. 1. Click the Telnet icon . The Configuration Set-Up window for the protocol displays. 2. Continue with the appropriate configuration procedure for the protocol you installed. (Instructions are on the APS CD.) 2. Click the Get Device Information button to display information. Firmware Type displays the protocol that is currently loaded on the device. Step 5: Load the Protocol . The Load 1. Click the Load icon Firmware window displays. |
Price & Availability of UDS-10-IAP
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |